The main components in the anchor zone of the CONA CMM SINGLE system are the wedge, monolithic anchorage and an individual trumpet tube. In the anchorage zone, the strand is guided into the individual trumpet tube to the monolithic anchorage, where the strand is individually locked with a special BBR wedge. The anchoring of the strand and load transfer to the concrete is done with one and the same unit, allowing for a high economy, small centre and edge distances at the anchorage, as well as application of the full post-tensioning load at very low concrete strengths.

CONA CMM anchorages are stressing/active anchorage (Type S) and the fixed/passive anchorage (Type F). Both types are identical. For construction works, the wedges of inaccessible fixed anchorages are secured by special wedge retaining measures and are protected by a cap during concreting. For restressable and exchangeable tendons, excess strand length is required at the anchorage. The extent of the excess strand length depends on the jack used for restressing or releasing and the strand protruding beyond the anchor head requires permanent corrosion protection and an adequate cap.