BBR HiAm CONA strand stay cable system

The BBR® HiAm CONA parallel strand stay cable system is the best product in the international market place. It has the highest capacity, most compact and widest range of anchorages available up to 217 strands. The BBR HiAm® CONA® stay cable system can be used for cable-stayed bridges, arch bridges and roofs. It fulfills latest international standards and recommendations including fib Bulletin 30 as well as PTI and Setra recommendations.

HiAm CONA stay cable system

Strong & sleek

This superior technology was developed and tested, and is continuously maintained by BBR engineers in Switzerland. Its superior fatigue resistance – “HiAm” stands for high amplitude fatigue resistance – makes it attractive for the most challenging of projects. Designers and architects have welcomed, in particular, the compactness of the anchorage and cable system, as it allows them greater scope to produce a structure which has sleeker lines and which appeals to the visual senses.

Stay cable system configuration

HiAm CONA cables are made up of a compacted bundle of a predetermined number of parallel seven-wire strands enclosed in a co-extruded (carbon black internal and colored external) ultra-violet resistant high-density polyethylene (HDPE) sheath of circular cross-section.

The individual strands generally have a diameter of 15.7 mm (0.62”), are of low relaxation grade, with nominal cross-sectional area of 150 mm2 and a minimum Guaranteed Ultimate Tensile Strength (GUTS) of 1,860 MPa.

The strands are galvanized, corrosion inhibited and individually sheathed with a continuous and wear resistant HDPE coating, providing each strand with an individual multilayer protection system with three nested barriers.

HiAm CONA Strand
HiAm CONA Strand Stay Pipe

Anchorage configuration

In the anchorage zone, the strand bundle passes a deviator and spreads out towards the compact socket, where each strand is individually guided, sealed leak tight and locked in the anchor heads with specially designed high fatigue resistant HiAm CONA wedges.

Ring nuts screwed onto the anchor heads transfer the cable loads by contact pressure onto the structure (HiAm CONA Nut Head configuration). Alternatively, the anchor heads may transfer the loads directly to the structure (HiAm CONA Uni Head configuration or BBR HiAm CONA Uni Head Short Socket configuration).

All BBR HiAm CONA anchorage components have been designed for a stress range greater than 300 MPa and to withstand the ultimate breaking load of the strand bundle with adequate safety.

In addition to the standard anchorage configurations, a Compact version is also offered which suits smaller openings in the bearing plate.

HiAm CONA Nut Head
HiAm CONA Uni Head

Installation & strand replacement

The installation of the BBR HiAm CONA System is typically performed on site using strand-by-strand installation. This is where each strand is tensioned immediately after installation, using the BBR ISOSTRESS tensioning method, ensuring an equal stress distribution among the strands of an individual cable. Alternatively to single-strand installation, fully or partially prefabricated cables can also be installed and tensioned using a multi-strand jack if access space is available.

Each individual strand installed in a BBR HiAm CONA Cable System can be replaced at any time during or after the installation, allowing not only for a restressing, but also for the selective removal, inspection, replacement or addition of individual strands.

HiAm CONA

Stay Cable System - Elegance and Strength

See our Downloads page

HiAm CONA stay CAD drawings



See our Downloads page

Benefits of BBR HiAm CONA:

  • Tendon capacity 200 – 60,000 kN
  • Superior fatigue resistance
  • Advanced water tightness
  • High corrosion protection
  • Compact anchorage and cable
  • Simple installation
  • Easy maintenance